Welcome to the Linux Foundation Forum!

15TB Storage question and problem

Options
fn0101
fn0101 Posts: 3
in Storage

Hi, I'm new in the community, but I have some experience in the tux world... I have a question, it is possible to attach a 10-disk array (1,5 TB each one) to a 32-bit linux platform? I'd try to mount them, but the kernel boot messages show this:

sd 1:0:1:0: [sdc] Write Protect is off

sd 1:0:1:0: [sdc] Mode Sense: 9f 00 00 08

sd 1:0:1:0: [sdc] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA

sd 1:0:1:1: [sdd] 0 512-byte logical blocks: (0 B/0 B)

sd 1:0:1:1: [sdd] 32768-byte physical blocks

sd 1:0:1:0: [sdc] Unsupported sector size 32768.

sd 1:0:1:1: [sdd] Write Protect is off

sd 1:0:1:1: [sdd] Mode Sense: 9f 00 00 08

sd 1:0:1:1: [sdd] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA

sd 1:0:1:0: [sdc] Attached SCSI disk

sd 1:0:1:1: [sdd] Unsupported sector size 32768.

sd 1:0:1:1: [sdd] Attached SCSI disk

There are 2 volumes, one of 4096 GB (sdc) an other of 9404 GB (sdd), both with 32KB physical sector-size. The question is: it is possible? there are a way to tune the kernel to accept this really big physical sector-size?

I'd try this in a 2.60MHz Xeon single-core machine with Debian lenny 5.0 distro with a v2.6.33 custom compiled kernel.

I would appreciate any answer.

Comments

  • woboyle
    woboyle Posts: 501
    Options
    It depends. What is your Linux distribution+version+kernel that you are using?
  • fn0101
    fn0101 Posts: 3
    Options
    Is at the bottom of the post, Debian Lenny 5.0, with 2.6.33 kernel, custom build, also I'd tried ubuntu 10.04 LTS server with default kernel (2.6.32-25-generic-pae), it show the same output...
  • woboyle
    woboyle Posts: 501
    Options
    The main issue is with the file system you are using. Since this array is almost 15TB in size, you will probably need to partition it into multiple file systems, though ext4 may handle the size.
  • fn0101
    fn0101 Posts: 3
    Options
    Thanks, i'd make that and also mounted a software raid and it´s ok. Now I have other problem, I can't setup quotas on this device, it's a raid 0 virtual disk and this is the output when I try to activate quotas:

    quotacheck: Mountpoint (or device) /storage01 not found or has no quota enabled.
    quotacheck: Cannot find filesystem to check or filesystem not mounted with quota option.

    And this is the line in the file fstab:

    /dev/md0 /storage01 ext4 defaults,noatime,nosuid,nodev,grpquota,sync,nodiratime 0 0

    Any suggestion?

Categories

Upcoming Training