Lab 2.1 Oracle VM VirtualBox

Hi All
After cautiously following the steps described in Lab 2.1, I am still unable, for some reasons, to start the VM as you could see in the attached picture.
1-Initially I had a first error which has been fixed using the cmd command : bcdedit /set hypervisorlaunchtype off
2- I've disabled/enabled VitualBox NDIS6 many times following the cmd command: ncpa.cpl

The only difference I can see from Lab 2.1 is my default Bridge Adapter - Realtek USB GBE Family Controller as opposed to Realtek PCIe GBE Family Controller. Could it be the issue? If not, has someone succeeded in starting the VM using the ...USB GBE driver?

cmd systeminfo:

OS Name: Microsoft Windows 10 Pro
Processor(s): 1 Processor(s) Installed.
[01]: Intel64 Family 6 Model 142 Stepping 12 GenuineIntel ~1792 Mhz
System Type: x64-based PC
Network Card(s): 5 NIC(s) Installed.
[01]: Intel(R) Wireless-AC 9560 160MHz
Connection Name: WiFi
DHCP Enabled: Yes
DHCP Server: xxxx
IP address(es)
[01]: xxxx
[02]: xxxxx
[03]: xxxxx
[04]: xxxx
[02]: Bluetooth Device (Personal Area Network)
Connection Name: Bluetooth Network Connection
Status: Media disconnected
[03]: Microsoft Wi-Fi Direct Virtual Adapter
Connection Name: Local Area Connection* 4
DHCP Enabled: No
IP address(es)
[01]: xxxx
[02]: xxxx
[04]: Hyper-V Virtual Ethernet Adapter
Connection Name: vEthernet (WSL)
DHCP Enabled: No
IP address(es)
[01]: xxxx
[02]: xxxx
[05]: VirtualBox Host-Only Ethernet Adapter
Connection Name: VirtualBox Host-Only Network
DHCP Enabled: No
IP address(es)
[01]: xxxx
[02]: xxxx
Hyper-V Requirements: VM Monitor Mode Extensions: Yes
Virtualization Enabled In Firmware: Yes
Second Level Address Translation: Yes
Data Execution Prevention Available: Yes

Looking forward to hearing from you.

Best